| Model | S-60-5 | S-60-12 | S-60-15 | S-60-24 |
|---|
| Specification |
| DC output voltage | 5V | 12V | 15V | 24V |
| Output voltage error(Note:) | ±2% | ±1% | ±1% | ±1% |
| Rated output current | 12A | 5A | 4A | 2.5A |
| Output current rage | 0-12A | 0-5A | 0-4A | 0-2.5A |
| Wave and noise(Note :3) | 120mVp-p | 120mVp-p | 150mVp-p | 150mVp-p |
| Inlet stability(Note :4) | ±0.5% | ±0.5% | ±0.5% | ±0.5% |
| Load stablity (Note :5) | ±1% | ±0.5% | ±0.5% | ±0.5% |
| DC output power | 60W | 60W | 60W | 40W |
| Efficiency | 72% | 76% | 77% | 79% |
| Adjustable range for DC voltage | +10,-5% | +10% | +10% | +10% |
| AC input voltage range | 85-264VAC 47-63Hz;120-370VDC |
| Input current | 2A/115V 60A/230V |
| AC INnrush current | Cold-start current 30A/115V 60A/230V
|
| Leakage current | <3.5mA/240VAC |
| Overload proctection | 105%~150% Tpye:pulsing hiccp shutdown Reset:auto recovery |
| Over-voltage protection | 115%~135% |
| High-temperature protection | ………… |
| Temperature coefficient | ±0.03%/ºC(0~50%) |
| Setup rise hold up time | 800ms,50ms,10ms/115V 300ms,50ms,80ms/230VAC |
| Vibration | 10-500HZ,2G 10min,/1cycle,Period for 60min,Each axes |
| Withstand voltage | Input and output internal:1.5KVAC,Input and enclosure:1.5KVAC,Output and enclosure:0.5KVAC |
| Isolation resistance | Input and output internal:Input and enclosure,Output and enclosure:500VDC/100MΩ |
| Working temperature and humidity | -10ºC~+60ºC(Refer to output derating curve),20%~90%RH |
| Store temperature and humidity | -20ºC~+85ºC,10%~95%RH |
| Overall dimension | 159×97×38mm |
| Weight | 0.55Kgs |
| Safety standards | UL1012 TUV EN6050(IEC,UL1950)Approved |
| EMC standards | CISPR22(EN55022),IEC801-2,3,4,IEC555-2 Verification |
Note:
1.The testing condition for the paramenter above is :230VAC input,rated load,25ºC70% RH.Humidity.
2.Error.include the setting error,line stability and load stability.(Note:5).
3.Wave test:adopting "A12"double wire for 20MHz,and 0.1UF&47UF capacitor short-circuit for interrupting.
4.Inlet voltage stability test:when is over load,the lowest voltage of inlet is up to the highest voltage.
5.Load stability test:the load is from 0% to 100%.
6.C2.3.6 must be knocked down. |
Inquiry Basket (
Single Output Switching Power Supply
